2018 / ECLIPSE CROSS / EC - Workshop Manual
42 -BODY > 42A-BODY > KEYLESS ENTRY SYSTEM<VEHICLES WITHOUT KEYLESS OPERATION SYSTEM><VEHICLES WITHOUT KEYLESS OPERATION SYSTEM> > SYMPTOM PROCEDURES > AFTER THE DOORS ARE UNLOCKED BY USING THE KEYLESS ENTRY SYSTEM, THE TIMER LOCK FUNCTION DOES NOT WORK.
Inspection Procedure 3: The timer lock function does not work after the doors have been unlocked by the keyless entry system.
| caution | Whenever the ECU is replaced, ensure that the input and output signal circuits are normal. |
COMMENT ON TROUBLE SYMPTOM
If the keyless entry timer lock does not work normally, the input signal circuit(s) to the keyless entry transmitter or the ETACS-ECU may be defective.
PROBABLE CAUSES
- Malfunction of the keyless entry transmitter
- Malfunction of the ETACS-ECU
- Damaged harness wires and connectors
DIAGNOSIS PROCEDURE
1. Check the operation of the keyless entry system.
2. Check the customise function.
3. Retest the system.
