[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
42 -BODY > 42A-BODY > KEYLESS ENTRY SYSTEM<VEHICLES WITHOUT KEYLESS OPERATION SYSTEM><VEHICLES WITHOUT KEYLESS OPERATION SYSTEM> > SYMPTOM PROCEDURES > POWER DOOR LOCKS WITH SELECTIVE UNLOCKING DOES NOT WORK.<Vehicles without dead lock system><Vehicles without dead lock system>
Inspection Procedure 5: Power door locks with selective unlocking does not work <Vehicles without dead lock system>.
 
 
cautionBefore replacing the ECU, ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
 
 
 
 
COMMENT ON TROUBLE SYMPTOM
If the keyless entry function works normally and only the power door locks with selective unlocking does not work normally, ETACS-ECU may be defective. In addition, it is possible that the function has been disabled by using the customisation function.
 
 
PROBABLE CAUSES
  • Malfunction of ETACS-ECU
  • Damaged wiring harness and connectors
 
 
DIAGNOSIS PROCEDURE
STEP 1. Check the customisation
Are the power door locks with selective unlocking enabled by the customization function?
Go to Step 2.
Set the "Door unlock mode" to "Driver’s door unlock" by using the customisation function. Refer to .
 
STEP 2. Keyless entry system operation check
Press the unlock switch of the transmitter and check that only the driver's door is unlocked. Then, press the unlock switch once again within 2 seconds after that to check that the front passenger's door, the rear doors and the tailgate are unlocked.
Does the keyless entry system work normally?
Go to Step 3.
NO (Only the driver's door is not unlocked) : Replace the ETACS-ECU and register the ID codes (Refer to ).
NO (The driver's door, front passenger's door, rear doors and tailgate are not unlocked) : Refer to Inspection Procedure 1: "Keyless entry system does not work ."
 
STEP 3. Check of the troubles
Check that the power door locks with selective unlocking works normally.
Is the check result normal?
Intermittent malfunction (Refer to GROUP 00, How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
Replace ETACS-ECU and register the ID codes (Refer to ).