[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
42 -BODY > 42B-KEYLESS OPERATION SYSTEM (KOS) > TROUBLESHOOTING > FORCED POWER SUPPLY OUTPUT PROCEDURE
FORCED POWER SUPPLY OUTPUT PROCEDURE
 
 
With KOS, the power supply cannot be turned "ON" until the certification communication with electrical steering lock is complete. However, using the M.U.T.-IIISE, the power can be forced "ON" even when the certification communication with electrical steering lock is not completed (However, locking/unlocking of the electrical steering lock is not performed.). Through this process, the error in certification with electrical steering lock can be distinguished from the malfunction in power supply. In addition, the process allows the CAN bus diagnosis as well as the reading of diagnosis code, belonging to systems other than KOS, to be performed.
 
 
 
 
FORCED POWER SUPPLY OUTPUT PROCEDURE
1. Connect the M.U.T.-IIISE to the diagnosis connector.
2. On the M.U.T.-IIISE system selection screen, select KOS/OSS/IMMO/Keyless.
3. Select Special Function from KOS/OSS/IMMO/Keyless screen. For vehicles with KOS, select with KOS.
4. Select Forced power supply output from Special Function screen.
5. From the forced power supply output screen, select the status with which the control is desired (Selection can be made from IG ACC, IG ON, and IG START).
6. On the execution confirmation screen, select "OK".
7. While the process is executed, the selected control status is maintained.
noteDuring the forced power supply output, the indicator flashes in orange.
8. To cancel the forced power supply output, select Forced power supply output (stop) on the Special Function screen, or operate the engine switch.