[ Model - ECLIPSE CROSS / Year - 2018 ]
Workshop Manual
Technical Information Manual
Body Repair Manual
Pre-delivery Inspection and Periodic Maintenance
PRINT
PRINT (GROUP)
2018 / ECLIPSE CROSS / EC - Workshop Manual
51 -EXTERIOR > REAR BUMPER ASSEMBLY > REAR BUMPER ASSEMBLY REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
Rear Combination Lamp Assembly Removal and Installation (Refer to GROUP 54A, Rear Combination Lamp
).
Overfender (Rear Bumper Moulding) Removal and Installation (Refer to
).
Splash Shield Rear (rear bumper side) Removal and Installation (Refer to GROUP 42A, Splash Shield
).
Damper Removal and Installation (Refer to GROUP 42A, Tailgate
).
Rear End Wiring Harness and Rear Bumper Wiring Harness Combination Connector
Removal steps
1.
Bolt (overfender side)
2.
Bolt (tailgate lower side)
3.
Bolt (tailgate upper side)
>>A<<
4.
Rear bumper assembly
5.
Rear bumper face support bracket
INSTALLATION SERVICE POINT
>>A<< REAR BUMPER ASSEMBLY INSTALLATION <VEHICLES WITH BLIND SPOT WARNING AND REAR CROSS TRAFFIC ALERT>
caution
Do not apply any sticker, paint or putty to the radar electric wave penetration area (shaded potion). Avoid any shocks or scratches.
The electric wave penetration areas are symmetrical on left and right.
