[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > TURN-SIGNAL LAMP > DIAGNOSIS CODE PROCEDURES > CODE NO. B16A6 TURN SIGNAL FUSE BLOWN
Code No.B16A6 Turn signal fuse blown
 
 
caution
  • Before replacing the ECU, ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
 
 
DIAGNOSTIC FUNCTION
When the hazard warning lamp fuse is blown, the ETACS-ECU sets the diagnosis code No. B16A6.
 
 
JUDGEMENT CRITERIA
With the diagnosis code not set, when the blown fuse of hazard warning lamp is detected three times consecutively, the ETACS-ECU sets the diagnosis code No. B16A6.
 
 
PROBABLE CAUSES
  • Damaged harness wires and connectors
  • Malfunction of the ETACS-ECU
 
 
DIAGNOSIS PROCEDURE
STEP 1. Fuse check
Check if the turn-signal lamp fuse is normal.
Is the check result normal?
Go to Step 2.
Replace the turn-signal lamp fuse.
 
STEP 2. Check whether the diagnosis code is set again.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3) Check if diagnosis code is set.
Is the diagnosis code set?
Replace the ETACS-ECU.
The diagnosis is complete.