[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > COMBINATION METER > SYMPTOM PROCEDURES > FUEL GAUGE DOES NOT WORK (BUT THE OTHER METERS WORK).
Inspection Procedure 8: Fuel gauge does not work (the other meters work).
 
 
cautionBefore replacing the combination meter, be sure to check that the power supply circuit, earth circuit, and communication circuit are normal.
 
 
COMMENTS ON TROUBLE SYMPTOM
If only the fuel gauge does not operate, the fuel pump and gauge unit (main), the fuel gauge unit (sub) <4WD> or the combination meter may be defective.
 
 
PROBABLE CAUSES
  • Malfunction of fuel pump and gauge unit (main)
  • Malfunction of the fuel gauge unit (sub) <4WD>
  • Malfunction of combination meter
 
 
DIAGNOSIS PROCEDURE
STEP 1. Check the diagnosis code.
Check if diagnosis code No. B1201 is set.
Is the diagnosis code No. B1201 set?
Perform the troubleshooting of when the diagnosis code is set (Refer to ).
Go to Step 2.
 
STEP 2. Fuel pump and gauge unit (main) and fuel gauge unit (sub) <4WD> check
Check the fuel pump and gauge unit (main) and fuel gauge unit (sub) <4WD>. Refer to .
Is the check result normal?
Go to Step 3.
Replace the fuel pump and gauge unit (main) and fuel gauge unit (sub) <4WD>.
 
STEP 3. M.U.T.-IIISE data list
  • Item 3: Fuel gauge (Refer to ).
  • Item 4: Fuel gauge(Target) (Refer to ).
Is the check result normal?
Go to Step 4.
Replace the combination meter.
 
STEP 4. M.U.T.-IIISE actuator test
  • Item 3: Fuel gauge (Refer to ).
Is the check result normal?
Go to Step 5.
Replace the combination meter.
 
STEP 5. Retest the system.
Check that combination meter illumination function should work normally.
Is the check result normal?
The procedure is complete. (If no malfunctions are found in all steps, an intermittent malfunction is suspected. Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
Replace the combination meter.