2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > COMBINATION METER > DIAGNOSIS CODE PROCEDURES > CODE No.U1195 CODING DATA NOT WRITTEN
Code No.U1195 Coding not completed
| caution | - If diagnosis code No. U1195 is set, diagnose the CAN bus lines.
- When replacing the ECU, always check that the communication circuit is normal.
|
TROUBLE JUDGEMENT
If the vehicle information data is not registered to the combination meter, the combination meter sets diagnosis code No. U1195.
JUDGEMENT CRITERIA
With the global coding counter value "0," if all the global coding data (vehicle information) are not set, the combination meter determines that a problem has occurred.
PROBABLE CAUSES
- Malfunction of CAN bus line
- Malfunction of combination meter
- Malfunction of the ETACS-ECU
DIAGNOSIS PROCEDURE
1. M.U.T.-IIISE CAN bus diagnostics.
2. Check if diagnosis code is set in the ETACS-ECU.
3. Check again if the diagnosis code is set in the combination meter.
