[ Model - ECLIPSE CROSS / Year - 2018 ]
HEIGHT SENSOR CHECK
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > HEADLAMP AUTOMATIC LEVELLING SYSTEM<Vehicles with headlamp auto levelling system><Vehicles with headlamp auto levelling system> > HEIGHT SENSOR > HEIGHT SENSOR CHECK
 
 
FRONT HEIGHT SENSOR CHECK
 
1. Disconnect the sensor connector and connect special tool test harness (MB991658) as shown.
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage of sensor connector terminal No. 2.
 
4. Check that voltages show the values described in the graph according to the sensor operation angle.
 
 
 
REAR HEIGHT SENSOR CHECK
 
1. Disconnect the sensor connector and connect special tool test harness (MB991658) as shown.
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage of sensor connector terminal No. 2.
 
4. Check that voltages show the values described in the graph according to the sensor operation angle.