2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > ULTRASONIC MISACCELERATION MITIGATION SYSTEM/CORNER SENSOR SYSTEM > DIAGNOSIS CODE PROCEDURES > CODE No. U1195 Coding not completed
Code No.U1195 Coding not completed
| caution | - If diagnosis code No. U1195 is set, be sure to diagnose the CAN bus line.
- When replacing the ECU, always check that the communication circuit is normal.
|
OPERATION
If the vehicle information data is not registered to the clearance warning control unit, the clearance warning control unit sets diagnosis code No. U1195.
TROUBLE JUDGEMENT
With the global coding counter value "0," if all the global coding data (vehicle information) are not set, the clearance warning control unit determines that a problem has occurred.
PROBABLE CAUSES
- Malfunction of CAN bas line
- Malfunction of ETACS-ECU
- Malfunction of clearance warning control unit
DIAGNOSIS PROCEDURE
1. M.U.T.-IIISE CAN bus diagnostics.
2. Check if diagnosis code is set in the ETACS-ECU.
3. Check whether the diagnosis code is set again.
