2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > MULTI AROUND MONITOR > DIAGNOSIS CODE PROCEDURES > Code No.B2542 SDRAM fail
Code No.B2542 SDRAM fault
TROUBLE JUDGEMENT
When the camera-ECU detects the internal error (SDRAM fail), it sets diagnosis code No.B2542.
| note | "!" mark is displayed on the vehicle icon when diagnosis code No.B2542 is set. |
PROBABLE CAUSES
- Failed calibration
- Malfunction of camera-ECU
DIAGNOSIS PROCEDURE
1. Check whether the diagnosis code is set again.
2. Replace the camera-ECU, and then repeat the calibration (Refer to 
). 