2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > MULTI AROUND MONITOR > DIAGNOSIS CODE PROCEDURES > Code No.U1195 Coding not completed
Code No.U1195 Coding not completed
| caution | If diagnosis code No.U1195 is set, be sure to diagnose the CAN bus line. |
TROUBLE JUDGEMENT
If the vehicle information data is not registered to the camera-ECU, the camera-ECU sets diagnosis code No.U1195.
| note | "!" mark is displayed on the vehicle icon when diagnosis code No.U1195 is set. |
PROBABLE CAUSES
- Variant coding not performed
- Malfunction of ETACS-ECU
- Malfunction of camera-ECU
- Malfunction of CAN bus
DIAGNOSIS PROCEDURE
1. M.U.T.-IIISE CAN bus diagnostics.
2. Check if diagnosis code is set in the ETACS-ECU.
3. Diagnosis code recheck.
