2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > MULTI AROUND MONITOR > DIAGNOSIS CODE PROCEDURES > Code No.B2548 Calibration not completed
Code No.B2548 Calibration not completed
TROUBLE JUDGEMENT
When the camera-ECU has not been calibrated, diagnosis code No.B2548 will be set.
| note | - "!" mark is displayed against the camera, which has not been calibrated yet, when diagnosis code No.B2548 is set.
- Diagnosis code No.B2548 will be erased automatically after learned values are written to the camera-ECU successfully or a relevant camera has been calibrated.
|
PROBABLE CAUSES
- The camera-ECU not calibrated
- Malfunction of camera-ECU
DIAGNOSIS PROCEDURE
Check whether the diagnosis code is set again.
