2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > MULTI AROUND MONITOR > DIAGNOSIS CODE PROCEDURES > Code No.B254F IG status fault
Code No.B254F IG status fault
TROUBLE JUDGEMENT
When the camera-ECU does not receive any ignition switch status signals from the ETACS-ECU for 5 seconds, diagnosis code No.B254F will be set.
PROBABLE CAUSES
- Malfunction of ETACS-ECU
- Malfunction of camera-ECU
- Malfunction of CAN bus
DIAGNOSIS PROCEDURE
1. M.U.T.-IIISE CAN bus diagnostics.
2. Check if diagnosis code No.U0141 is set.
3. Check whether the diagnosis code is set again.
