2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > RADIO AND CD PLAYER > DIAGNOSIS CODE PROCEDURES > CODE NO.U1195 CODING NOT COMPLETED
Code No. U1195 Coding not completed
| caution | - If the diagnosis code No. U1195 is set, be sure to diagnose the CAN bus line.
- When replacing the radio and CD player, always check that the communication circuit is normal.
- When the diagnosis code No. U1195 is set in radio and CD player, the diagnosis code may also be set in ETACS-ECU. When the diagnosis code is set in ETACS-ECU, carry out the diagnosis of the diagnosis code for ETACS-ECU first.
|
JUDGEMENT CRITERIA
This diagnosis code is set when the variant coding for ETACS-ECU has not been implemented.
PROBABLE CAUSES
- Variant coding for ETACS-ECU has not been implemented.
- Malfunction of radio and CD player
DIAGNOSIS PROCEDURE
1. M.U.T.-IIISE CAN bus diagnosis.
2. Check if diagnosis code is set in the ETACS-ECU.
3. Check whether the diagnosis code is set again.
