2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > SMARTPHONE LINK DISPLAY AUDIO > DIAGNOSIS CODE PROCEDURES > CODE NO.U1195 CODING NOT COMPLETED
Code No.U1195: Coding not completed
| caution | - If diagnosis code No. U1195 is set, diagnose the CAN bus lines.
- When replacing the ECU, always check that the communication circuit is normal.
|
TROUBLE JUDGEMENT
If the vehicle information data is not registered to the combination meter, the multivision display sets diagnosis code No. U1195.
JUDGEMENT CRITERIA
With the global coding counter value "0," if all the global coding data (vehicle information) are not set, the multivision display determines that a problem has occurred.
PROBABLE CAUSES
- Malfunction of CAN bus line
- Malfunction of multivision display
- Malfunction of the ETACS-ECU
DIAGNOSIS PROCEDURE
1. M.U.T.-IIISE CAN bus diagnosis.
2. Check if diagnosis code is set in the ETACS-ECU.
3. Check whether the diagnosis code is set again.
