[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > HEADLAMP > DIAGNOSIS CODE PROCEDURES > CODE No. B1E2A Driver(CH6) defective(OPN/Short)
Code No.B1E2A Multichannel Driver CH6 Defective (Open/Short)
 
 
cautionBefore replacing the ECU, ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
 
 
DIAGNOSTIC FUNCTION
If the high-beam headlamps do not function, the ETACS-ECU will set diagnosis code No. B1E2A.
 
 
JUDGEMENT CRITERIA
Diagnosis code No. B1E2A will be set if the ETACS-ECU detects a short to power supply between the headlamp relay (HI) and the ETACS-ECU.
 
 
PROBABLE CAUSES
  • Damaged harness wires and connectors
  • Malfunction of the ETACS-ECU
 
 
DIAGNOSIS PROCEDURE
STEP 1. Check of short to power supply circuit in HHI line between the headlamp relay (HI) connector and ETACS-ECU connector.
Is the check result normal?
Go to Step 2.
Repair the connector(s) or wiring harness.
 
STEP 2. Check whether the diagnosis code is set again.
Check again if the diagnosis code No.B1E2A is set in the ETACS-ECU.
(1) Erase the diagnosis code.
(2) Turn on the headlamp.
(3) Check if diagnosis code is set.
Is the diagnosis code set?
Replace the ETACS-ECU.
The trouble can be an intermittent malfunction (GROUP 00 - How to use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).