2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > HEADLAMP > DIAGNOSIS CODE PROCEDURES > CODE No. B1E15 HEADLAMP (RH)(LOW BEAM) FET FAIL
Code No.B1E15 Low Beam Lamp(RH) deactivated (FET failure)
| caution | Before replacing the ECU, ensure that the power supply circuit, the earth circuit and the communication circuit are normal. |
DIAGNOSTIC FUNCTION
Diagnosis code No. B1E15 will be set when the headlamp (Low-beam) (RH) control circuit in the ETACS-ECU fails.
JUDGEMENT CRITERIA
Diagnosis code No. B1E15 will be set when the ETACS-ECU detects a short to earth in its headlamp (Low-beam) (RH) control circuit.
PROBABLE CAUSES
- Headlamp (Low-beam) (RH) control circuit fails
- Malfunction of the ETACS-ECU
DIAGNOSIS PROCEDURE
M.U.T.-IIISE diagnosis code
Check if the diagnosis code No. B1E11 is set to the ETACS-ECU.Is the diagnosis code set?
Carry out the troubleshooting for diagnosis code No. B1E11. On completion, replace the ETACS-ECU when it has not been replaced as the troubleshooting process for diagnosis code No. B1E11. This is because diagnosis code No. B1E15 cannot be erased.
Replace the ETACS-ECU.
