STEP 2. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the FCM/LDW/AHB-ECU.(1) Erase the diagnosis code.
(2) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3) Drive the vehicle for approx. five minutes.
(4) Check if diagnosis code is set.
Is the diagnosis code set?
Replace the FCM/LDW/AHB-ECU (Refer to
).
A component protection has been triggered due to a bad weather or unfavourable environments. This is not a malfunction.