2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > FCM/LDW/AHB-ECU > DIAGNOSIS CODE PROCEDURES > CODE NO. C1754 Radar calibration not completed
Code No. C1754 Radar calibration not completed
OPERATION
The FCM/LDW/AHB-ECU memorises the neutral position of its sensor.
DIAGNOSIS CODE SET CONDITION
This diagnosis code is set when the abnormality below is detected:
- The FCM/LDW/AHB-ECU detects that the neutral position of its sensor is not learned yet.
PROBABLE CAUSES
- Neutral position of the FCM/LDW/AHB-ECU sensor not learned
DIAGNOSIS PROCEDURE
FCM/LDW/AHB-ECU sensor calibration.
).
This diagnosis is complete.
Identify why the calibration fails, and then calibrate the FCM/LDW/AHB-ECU sensor.