[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > FCM/LDW/AHB-ECU > DIAGNOSIS CODE PROCEDURES > CODE NO. C2292 Auto calibration out of range
Code No. C2292 Auto calibration out of range
 
 
caution
  • Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
 
 
OPERATION
The FCM/LDW/AHB-ECU adjusts the sensor axis automatically during driving.
 
 
DIAGNOSIS CODE SET CONDITION
This diagnosis code is set when any of the following conditions is detected:
  • A sensor axis compensation reaches its limit due to too heavy load, improper wheel alignment or tyre punctuation.
 
 
PROBABLE CAUSES
  • Unfavourable vehicle condition, such as too heavy load, improper wheel alignment or tyre punctuation
  • Improperly installed FCM/LDW/AHB-ECU
  • Malfunction of the FCM/LDW/AHB-ECU
 
 
DIAGNOSIS PROCEDURE
STEP 1. Check the vehicle for proper condition.
Check whether the vehicle attitude is affected. (Heavy load, tyre inflation pressure, or wheel alignment)
Is the check result normal?
Go to Step 2
Rectify the vehicle condition.
 
STEP 2. Check whether the FCM/LDW/AHB-ECU is installed properly.
Is the check result normal?
Go to Step 3
Install the FCM/LDW/AHB-ECU properly.
 
STEP 3. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the FCM/LDW/AHB-ECU.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3) Drive the vehicle for approx. ten minutes.
(4) Check if diagnosis code is set.
Is the diagnosis code set?
Calibrate the FCM/LDW/AHB-ECU sensor) (Refer to ).
This diagnosis is complete