[ Model - ECLIPSE CROSS / Year - 2018 ]
PRINT
PRINT (GROUP)
| Error messages | Cause | Cause of trouble and its solution | |
| Data cannot be read due to low temperatures. Please wait. | Too cold SD card | If the system detects that the SD card is too cold or hot, an error message will be displayed. Wait until the temperature of the SD card returns to normal operating temperature. | |
| Data cannot be read due to high temperatures. Please wait. | Too hot SD card | ||
| Map card data cannot be read. Check the map card. | Defective SD card (for system operation) | If the system cannot gain access to the SD card (for system operation), an error message will be displayed. | |
| The monitor panel is hot. Display has been halted to protect the LCD panel. Please wait for its temperature to drop. | Too hot display monitor | If the display monitor is too hot, an error message will be displayed. After the error message is displayed, the screen will be shut down. Wait until the temperature of the monitor drops. | |
| The map card is not inserted into the map slot. Insert the map card included in this unit into the map slot. | SD card (for system operation) not inserted | If the system detects that a SD card is ejected, an error message will be displayed. Check whether the SD card is inserted securely in the SD card slot. | |
| Map cannot be displayed. | Map data is not read correctly | If the system cannot gain access to the SD card (for system operation), an error message will be displayed. | |
| Error messages | Cause | Cause of trouble and its solution | |
| Cannot be played. Check the disk. | Focus error | These error codes will be shown if there is any problem with the CD or there is excessive vibration on the vehicle. If the error codes are not displayed when the vehicle is stopped and another CD is inserted, there is a problem with the CD. Check if there is any of the following problems with the CD.
Repair the CD and insert it again. Then, check that no error appears. | |
| Disk type error | |||
| Abnormal disc | |||
| Play is impossible due to high temperatures. Remove the disk, and wait a short while. | Protection against high temperature | If the internal temperature is extremely high, this error code will be shown. Turn off the radio and CD player and wait until they cool down. Wait for a while, and then turn on the unit again. Check that the same error does not appear. | |
| Play is impossible due to a mechanism error. | Abnormal load/eject | This error codes will be shown if there is any internal mechanical or electrical problem in the radio and CD player. Replace the radio and CD player check that no error codes are shown. | |
| Power supply error | This error code will be shown if there is any problem in the power supply system of the radio and CD player. Check the connectors and wiring harness of the power supply system, and check that the battery voltage is normal. Check that the same error does not appear. | ||
| Error messages | Cause | Cause of trouble and its solution | |
| The SD card cannot be recognized. | Defective device | If no file can be read due to a defective SD device, an error message will be displayed. | |
| Internal ROM | |||
| Communication error | |||
| The music SD card cannot be recognized. | Defective device | If no audio file can be read due to a defective SD device, an error message will be displayed. | |
| Error with authentication. | SD memory card cannot be authenticated. | The SD memory card is not authenticated. Reconnect. | |
| Error messages | Cause | Cause of trouble and its solution | |
| An error (internal ROM) occurred. | Hands free-ECU internal error | This error code will be shown when there is a problem in the hands free-ECU. Replace the hands free-ECU. | |
| An error (excess current) occurred. | Overcurrent abnormality | There is a communication error with the hands free-ECU. | |
| No data that can be played. | No playable music file is found. | No playable music file is stored in the USB memory. Store music files to the USB memory. | |
| This file cannot be played. | Unsupported format | The USB memory is not supported by the hands free-ECU. Use the supported USB memory. | |
| This USB device cannot be played. | Unsupported device | ||
| Communication with USB memory is not possible. Please try reconnecting. | USB memory cannot be authenticated. | The USB memory is not authenticated. Reconnect. | |
| Error messages | Cause | Cause of trouble and its solution | |
| No data that can be played. | No playable music file is found. | No playable music file is stored in the iPod®. Store music files to the iPod. | |
| This iPod cannot be played. | Incorrect firmware version | iPod itself or software is not supported. Use the supported iPod®. | |
| Error with iPod authentication. | iPod cannot be authenticated. | iPod® is not authenticated. Reconnect. | |