[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54C-CONTROLLER AREA NETWORK (CAN) > TROUBLESHOOTING<GATEWAY><GATEWAY> > DIAGNOSIS CODE CHART
DIAGNOSIS CODE CHART
cautionDuring troubleshooting, a diagnosis code associated with other systems may be set when the ignition switch is turned "ON" with connector(s) disconnected. On the completion of troubleshooting, confirm all systems for diagnosis code(s). If diagnosis code(s) are set, erase them all.
Diagnosis code No.Diagnostic itemReference page
B1083EEPROM fail
U0141ETACS CAN timeout
U1073Bus-off
U1190No receive fault detect signal