[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > BLIND SPOT WARNING (BSW)/REAR CROSS TRAFFIC ALERT (RCTA) > DATA LIST REFERENCE TABLE
DATA LIST REFERENCE TABLE
 
 
 
 
The following items of the ECU input data can be read using M.U.T.-IIISE.
note*: Only applicable to the BSW-ECU (master).
Item No.M.U.T.-IIISE displayCheck conditionNormal condition
1*BSW statusIgnition switch: OFF-
  • Ignition switch: ON
  • Blind spot warning switch: OFF
OFF
  • Ignition switch: ON
  • Blind spot warning switch: ON
  • Vehicle speed: less than 10 km/h or selector lever position: R
Standby
  • Ignition switch: ON
  • Blind spot warning switch: ON
  • Vehicle speed: 10 km/h or more
  • Selector lever position: except R
Active
The BSW is not functioning temporarily (except diagnosis and status indication).Temporary fail
The BSW is not functioning (except diagnosis and status indication).Fail
2*RCTA statusIgnition switch: OFF-
  • Ignition switch: ON
  • Blind spot warning switch: OFF
OFF
  • Ignition switch: ON
  • Blind spot warning switch: ON
  • Vehicle speed: more than 18 km/h or selector lever position: except R
Standby
  • Ignition switch: ON
  • Blind spot warning switch: ON
  • Vehicle speed: 18 km/h or less
  • Selector lever position: R
Active
The RCTA is not functioning temporarily (except diagnosis and status indication).Temporary fail
The RCTA is not functioning (except diagnosis and status indication).Fail
3BSW operation mode (Last)BSW operation status (the last): "Not activated" is storedOFF
BSW operation status (the last): "Activated" is storedON
4Ignition voltageIgnition switch: ONSystem voltage
5Shift positionSelector lever position: PP
Selector lever position: RR
Selector lever position: NN
Selector lever position: except P, R and ND / Not R(MT)
Selector lever position unknownUndetermined
6Vehicle speedRunningVehicle speed
7Steering angle sensorVehicle stopped (the steering wheel is in the neutral position)-5 to 5 deg
RunningNearly the same as the steering wheel operation angle <-720 to 720 deg>
8Steering angle sensor statusSteering wheel sensor: OKNormal
When the steering wheel sensor neutral point is not learnedNot initialised
When the steering wheel sensor is defectiveFault
The steering wheel sensor fails and has not been learnt yetFault & Not initialised
9Turn signal switch LHColumn switch (left turn-signal lamp): OFFOFF
Column switch (left turn-signal lamp): ONON
10Turn signal switch RHColumn switch (right turn-signal lamp): OFFOFF
Column switch (right turn-signal lamp): ONON
12Radar stateThe BSW-ECU is normal.Normal
The BSW-ECU failsHardware failure
The CAN bus lines or the blind spot warning lamp on door mirror fails or the ETACS-ECU has not been coded yetDegradation
The BSW-ECU is not functioning due to a foreign material adhered on it.Blockage
Malfunction or reduced performance other than "Hardware failure", "Degradation" and "Blockage"Undetermined
14BSW ON/OFF setting signalNo BSW ON/OFF SW operationNo Request
BSW OFF SW inputOFF*
BSW ON SW inputON*
-Not defined
note*: Output for 200 ms.