2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > BLIND SPOT WARNING (BSW)/REAR CROSS TRAFFIC ALERT (RCTA) > DIAGNOSIS CODE PROCEDURES<MASTER><MASTER> > CODE No. C2325/C2326 Radar horizontal misalignment(L)/(R)
CODE No. C2325 Radar horizontal misalignment(L)
CODE No. C2326 Radar horizontal misalignment(R)
| caution | Before replacing the ECU, ensure that the power supply circuit, the earth circuit and the communication circuit are normal. |
OPERATION
The BSW-ECU (master) incorporates a radar, and compensates its deviation automatically during driving.
CHECK CONDITION
When all of the conditions below are satisfied:
- Ignition switch is in the "ON" position.
- BSW-ECU (master) system voltage is at 9 - 16 V.
DIAGNOSTIC FUNCTION AND JUDGEMENT CRITERIA
- When the horizontal axis of the radar deviates by 5° or more clockwise, the BSW-ECU (master) sets diagnosis code No.C2325.
- When the horizontal axis of the radar deviates by 5° or more anticlockwise, the BSW-ECU (master) sets diagnosis code No.C2326.
PROBABLE CAUSES
- Improper vehicle attitude due to heavy load, improper wheel alignment, or tyre puncture
- Improperly installed BSW-ECU (master)
- Malfunction of the BSW-ECU (master)
DIAGNOSIS PROCEDURE
1. Check load in luggage compartment, tyre inflation pressure, or wheel alignment.
2. Check whether the BSW-ECU (master) is installed in right angle (Refer to 
). 3. Check whether the diagnosis code is set again, after driving the vehicle for at least 10 minutes.
