2018 / ECLIPSE CROSS / EC - Workshop Manual
54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > BLIND SPOT WARNING (BSW)/REAR CROSS TRAFFIC ALERT (RCTA) > DIAGNOSIS CODE PROCEDURES<MASTER><MASTER> > CODE No. U1195 Coding not completed
CODE No. U1195 Coding not completed
| caution | - If diagnosis code No. U1195 is set in the BSW-ECU (master), always diagnose the CAN bus line.
- Before replacing the ECU, ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
|
CHECK CONDITION
Ignition switch is in the "ON" position.
DIAGNOSTIC FUNCTION AND JUDGEMENT CRITERIA
When the BSW-ECU (master) cannot store any vehicle information data, the ECU sets diagnosis code No. U1195.
PROBABLE CAUSES
- The ETACS-ECU has not been coded yet.
- Malfunction of the ETACS-ECU
- Malfunction of the BSW-ECU (master)
- Malfunction of the CAN bus
DIAGNOSIS PROCEDURE
1. M.U.T.-IIISE CAN bus diagnostics.
2. Check if diagnosis code No. B222C is set in the ETACS-ECU.
3. Check whether the diagnosis code is set again.
