[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
55 -HEATER, AIR CONDITIONER AND VENTILATION > TROUBLESHOOTING > DIAGNOSIS CODE PROCEDURES > U1195 CODING NOT COMPLETED
Code No.U1195 Coding not completed
 
 
caution
  • If diagnosis code No. U1195 is set, diagnose the CAN bus lines.
  • When replacing the ECU, always check that the communication circuit is normal.
  • When the ETACS-ECU of vehicles without KOS is replaced, the encrypted code of the ignition key needs to be registered to the ETACS-ECU. (If the encrypted code is not registered, the engine cannot be started. Register the encrypted code as described in Immobilizer System - How to Register Key ID .)
 
 
DIAGNOSTIC FUNCTION
If the vehicle information data is not registered to the ETACS-ECU, the A/C controller assembly (A/C-ECU) sets diagnosis code No. U1195.
 
 
PROBABLE CAUSES
  • Malfunction of CAN bus line
  • Malfunction of A/C controller assembly (A/C-ECU)
  • Malfunction of the ETACS-ECU