Nissan GT-R (R35) · Service Manual
ENGINE
ENGINE › ENGINE CONTROL SYSTEM › COMPONENT DIAGNOSIS
P0605 ECM
VR38
P0605
Description
DTC Logic
Diagnosis Procedure
Description
The ECM consists of a microcomputer and connectors for signal input and output and for power supply. The ECM controls the engine.
DTC Logic
DTC DETECTION LOGIC
DTC No.
Trouble diagnosis name
DTC detecting condition
Possible cause
P0605
Engine control module
A)
ECM calculation function is malfunctioning.
ECM
B)
ECM EEP-ROM system is malfunctioning.
C)
ECM self shut-off function is malfunctioning.
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.
>>
GO TO 2
.
2.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A
Turn ignition switch ON.
Check 1st trip DTC.
Is 1st trip DTC detected?
YES
>>
Go to
Diagnosis Procedure (GT-R certified NISSAN dealer)
.
NO
>>
GO TO 3
.
3.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B
Turn ignition switch ON and wait at least 1 second.
Turn ignition switch OFF, wait at least 10 seconds, and then turn it ON.
Check 1st trip DTC.
Is 1st trip DTC detected?
YES
>>
Go to
Diagnosis Procedure (GT-R certified NISSAN dealer)
.
NO
>>
GO TO 4
.
4.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION C
Turn ignition switch ON and wait at least 1 second.
Turn ignition switch OFF, wait at least 10 seconds, and then turn it ON.
Repeat step 2 for 32 times.
Check 1st trip DTC.
Is 1st trip DTC detected?
YES
>>
Go to
Diagnosis Procedure (GT-R certified NISSAN dealer)
.
NO
>>
INSPECTION END
Diagnosis Procedure
1.INSPECTION START
Turn ignition switch ON.
Erase DTC.
Perform DTC Confirmation Procedure.See
DTC Logic
.
Is the 1st trip DTC P0605 displayed again?
YES
>>
GO TO 2
.
NO
>>
INSPECTION END
2.REPLACE ECM
Replace ECM.
Go to
Special Repair Requirement
.
>>
INSPECTION END