COMBINATION METER

Check that the following fuses are not blown:

Power source	Fuse No.
Battery	11
Ignition switch ON or START	4

YES>>GO TO 2.

NO>>Replace the fuse with a new one after repairing the applicable circuit.

Check the voltage between the combination meter harness connector terminals and the ground.

Terminal No.	Signal name	Ignition switch	Voltage
1	Battery power supply	OFF	Battery voltage
2	IGN signal	ON	Battery voltage

YES>>GO TO 3.

NO>>Repair the harness between the fuse and the combination meter.

1. Turn the ignition switch OFF.
2. Disconnect the combination meter connector.
3. Check for continuity between the combination meter harness connector terminals and the ground.
   

   Combination meter		Ground	Continuity
   Connector	Terminal
   M53	3		Existed
   	5

   
   

YES>>INSPECTION END

NO>>Repair the harnesses or connectors.