METER CONTROL SWITCH SIGNAL CIRCUIT

1. Turn the ignition switch ON.
2. Measure voltage between the following terminals of the combination meter.
   

   Terminal No.	Condition	Voltage
   23 – 6	When switch is pressed	0 V
   	Other than the above	5 V
   24 – 6	When switch is pressed	0 V
   	Other than the above	5 V
   25 – 6	When trip A/B reset switch is pressed	0 V
   	Other than the above	5 V
   26 – 6	When switch is pressed	0 V
   	Other than the above	5 V
   27 – 6	When switch is pressed	0 V
   	Other than the above	5 V

   
   

YES>>INSPECTION END

NO>>GO TO 2.

1. Turn the ignition switch OFF.
2. Disconnect the connectors of combination meter and meter control switch.
3. Check for continuity between the combination meter harness connector terminal and the meter control switch harness connector.
   

   Combination meter		Meter control switch		Continuity
   Connector	Terminal	Connector	Terminal
   M53	6	M54	2	Existed
   	23		3
   	24		1
   	25		8
   	26		6
   	27		7

   
   
4. Check for continuity between the combination meter harness connector and the ground.
   

   Combination meter		Ground	Continuity
   Connector	Terminal
   M53	6		Not existed
   	23
   	24
   	25
   	26
   	27

   
   

YES>>INSPECTION END

NO>>Repair the harnesses or connectors.

1. Turn the ignition switch OFF.
2. Disconnect the meter control switch connector.
3. Check the continuity of meter control switch.
   

   Terminal No.		Operation and status	Continuity
   6	2	Press the switch	Existed
   		Other than the above	Not existed
   7	2	Press the switch	Existed
   		Other than the above	Not existed
   8	2	Press the trip A/B reset switch.	Existed
   		Other than the above	Not existed
   3	2	Press the switch	Existed
   		Other than the above	Not existed
   1	2	Press the switch	Existed
   		Other than the above	Not existed

   
   

YES>>INSPECTION END

NO>>Replace the meter control switch.