Nissan GT-R (R35) · Service Manual SUSPENSION

C1D02 YAW RATE/SIDE/DECEL G SENSOR

Bilstein DampTronic

C1D02

Description


The side G sensor signal is transmitted from the ABS actuator and electric unit (control unit) to E-SUS control unit via CAN communication.

DTC Logic

 
 DTC DETECTION LOGIC

DTC
 		Display Item
 		Malfunction detected condition
 		Possible causes
C1D02
 		SIDE G-SENSOR SIG
  • A malfunction is detected in the side G sensor signal output from the yaw rate/side/decel G sensor to CAN communication.
  • No transmission from the yaw rate/side/decel G sensor.
  • Harness or connector (CAN communication line)
  • ABS actuator and electric unit (control unit)
  • E-SUS control unit

 
 DTC REPRODUCTION PROCEDURE

 
 1.DTC REPRODUCTION PROCEDURE

Diagnosis Procedure


■ CAUTION ■
 In the Bilstein DampTronic system, because it is difficult to distinguish a sensor malfunction from normal operation when the vehicle turns sharply such as spin turning, turning while accelerating, or drift driving, or when CONSULT-III is connected to the vehicle, the vehicle enters the fail-safe status and a DTC is stored once. If the normal operation is restored later, it is not a malfunction. At that time, erase the self-diagnosis memory. If the normal operation is not restored, perform the following diagnosis procedure.
 
 1.PERFORM SELF-DIAGNOSIS OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
 
 2.PERFORM SELF-DIAGNOSIS
 
 3.CHECK INFORMATION