WIPER
DIAGNOSIS SYSTEM (BCM)
WORK SUPPORT|
Service item |
Setting item |
Description |
|
WIPER SPEED SETTING |
On |
With vehicle speed (Front wiper intermittent time linked with the vehicle speed and wiper intermittent dial position) |
|
Off* |
Without vehicle speed (Front wiper intermittent time linked with the wiper intermittent dial position) |
DATA MONITOR|
Monitor Item [Unit] |
Description |
|
PUSH SW [Off/On] |
The switch status input from push-button ignition switch. |
|
VEHICLE SPEED 1 [km/h] |
The value of the vehicle speed signal received from combination meter with CAN communication. |
|
FR WIPER HI [Off/On] |
Each switch status that BCM judges from the combination switch reading function. |
|
FR WIPER LOW [Off/On] |
|
|
FR WASHER SW [Off/On] |
|
|
FR WIPER INT [Off/On] |
|
|
FR WIPER STOP [Off/On] |
Front wiper motor (stop position) status received from IPDM E/R with CAN communication. |
|
INT VOLUME [1 − 7] |
Each switch status that BCM judges from the combination switch reading function. |
ACTIVE TEST|
Test item |
Operation |
Description |
|
FR WIPER |
Hi |
Transmits the front wiper request signal (HI) to IPDM E/R with CAN communication to operate the front wiper HI operation. |
|
Lo |
Transmits the front wiper request signal (LO) to IPDM E/R with CAN communication to operate the front wiper LO operation. |
|
|
INT |
Transmits the front wiper request signal (INT) to IPDM E/R with CAN communication to operate the front wiper INT operation. |
|
|
Off |
Stops transmitting the front wiper request signal to stop the front wiper operation. |