FRONT WIPER AUTO STOP SIGNAL CIRCUIT

CONSULT-III DATA MONITOR

1. Select “WIP AUTO STOP” of IPDM E/R data monitor item.
2. Operate the front wiper.
3. With the front wiper operation, check the monitor status.
   

   Monitor item	Condition		Monitor status
   WIP AUTO STOP	Front wiper motor	Stop position	STOP P
   		Except stop position	ACT P

   
   

YES>>Auto stop signal circuit is normal.

NO>>Refer to Diagnosis Procedure.

1. Turn the ignition switch OFF.
2. Disconnect front wiper motor connector.
3. Turn the ignition switch ON.
4. Check voltage between IPDM E/R harness connector and ground.

Terminals			Voltage (Approx.)
(+)		(−)
IPDM E/R		Ground
Connector	Terminal
E5	16		Battery voltage

YES>>GO TO 3.

NO>>GO TO 2.

1. Turn the ignition switch OFF.
2. Disconnect IPDM E/R connector.
3. Check continuity between IPDM E/R harness connector and ground.

IPDM E/R		Ground	Continuity
Connector	Terminal
E5	16		Not existed

YES>>Repair the harnesses or connectors.

NO>>Replace IPDM E/R.

Check continuity between IPDM E/R harness connector and front wiper motor harness connector.

IPDM E/R		Front wiper motor		Continuity
Connector	Terminal	Connector	Terminal
E5	16	E42	5	Existed

YES>>Replace front wiper motor.

NO>>Repair the harnesses or connectors.