POWER WINDOW SUB-SWITCH

Check that passenger side power window operates when power window sub-switch (power window lock switch is UNLOCK) is operated to the AUTO position.

YES>>Power window sub-switch AUTO function is OK.

NO>>Refer to Diagnosis Procedure.

1. Turn ignition switch ON.
2. Power window lock switch UNLOCK.
3. Check voltage between passenger side power window motor harness connector and ground.
   

   (+)		(−)	Condition		Voltage (V) (Approx.)
   Passenger side power window motor
   Connector	Terminal
   D40	1	Ground	Power window sub-switch	AUTO	Battery voltage
   				Other than above	0

   
   

YES>>Replace passenger side power window motor. Refer to Removal and Installation (GT-R certified NISSAN dealer).

NO>>GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect passenger side power window motor connector and power window sub-switch connector.
3. Check continuity between passenger side power window motor harness connector and power window sub-switch harness connector.
   

   Passenger side power window motor		Power window sub-switch		Continuity
   Connector	Terminal	Connector	Terminal
   D40	1	D38	14	Existed

   
   
4. Check continuity between passenger side power window motor harness connector and ground.
   

   Passenger side power window motor		Ground	Continuity
   Connector	Terminal
   D40	1		Not existed

   
   

YES>>GO TO 3.

NO>>Repair or replace harness.

Check power window sub-switch.
Refer to Component Inspection.

YES>>GO TO 4.

NO>>Replace power window sub-switch. Refer to Removal and Installation.

Refer to Intermittent Incident.

>>INSPECTION END