POWER WINDOW SUB-SWITCH

Check that power window sub-switch illuminates when ignition switch turns ON.

YES>>Power window sub-switch illumination circuit is OK.

NO>>Refer to Diagnosis Procedure.

1. Turn ignition switch ON.
2. Check voltage between power window sub-switch harness connector and ground.
   

   (+)		(−)	Voltage (V) (Approx.)
   Power window sub-switch
   Connector	Terminal
   D38	11	Ground	Battery voltage

   
   

YES>>GO TO 3.

NO>>GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect power window sub-switch connector and passenger side power window motor connector.
3. Check continuity between power window sub-switch harness connector and passenger side power window motor harness connector.
   

   Power window sub-switch		Passenger side power window motor		Continuity
   Connector	Terminal	Connector	Terminal
   D38	11	D40	2	Existed

   
   
4. Check continuity between power window sub-switch harness connector and ground.
   

   Power window sub-switch		Ground	Continuity
   Connector	Terminal
   D38	11		Not existed

   
   

YES>>GO TO 4.

NO>>Repair or replace harness.

1. Turn ignition switch OFF.
2. Disconnect power window sub-switch connector.
3. Check continuity between power window sub-switch harness connector and ground.
   

   Power window sub-switch		Ground	Continuity
   Connector	Terminal
   D38	8		Existed

   
   

YES>>Replace power window sub-switch. Refer to Removal and Installation.

NO>>Repair or replace harness.

Refer to Intermittent Incident.

>>INSPECTION END