ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION

INSPECTION AND ADJUSTMENT · VDC/TCS/ABS

Description
Special Repair Requirement

Description

When doing work that applies to the list below, make sure to adjust neutral position of steering angle sensor before running vehicle.

×: Required –: Not required

Situation	Adjustment of steering angle sensor neutral position
Removing/Installing ABS actuator and electric unit (control unit)	—
Replacing ABS actuator and electric unit (control unit)	×
Removing/Installing steering angle sensor	×
Replacing steering angle sensor	×
Removing/Installing steering components	×
Replacing steering components	×
Removing/Installing suspension components	×
Replacing suspension components	×
Changing old tires to new ones	—
Adjusting wheel alignment	×

Special Repair Requirement

ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION

■ CAUTION ■
To adjust neutral position of steering angle sensor, make sure to use CONSULT-III.
(Adjustment cannot be done without CONSULT-III)

1.ALIGN THE VEHICLE STATUS

2.PERFORM THE NEUTRAL POSITION ADJUSTMENT FOR THE STEERING ANGLE SENSOR

3.CHECK DATA MONITOR

4.ERASE THE SELF-DIAGNOSIS MEMORY