Nissan GT-R (R35) · Service Manual
BRAKES
BRAKES › BRAKE CONTROL SYSTEM › COMPONENT DIAGNOSIS
C1110 ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
VDC/TCS/ABS
C1110
DTC Logic
Diagnosis Procedure
Special Repair Requirement
DTC Logic
DTC DETECTION LOGIC
DTC
Display item
Malfunction detected condition
Possible cause
C1110
CONTROLLER FAILURE
When there is an internal malfunction in the ABS actuator and electric unit (control unit).
ABS actuator and electric unit (control unit)
DTC CONFIRMATION PROCEDURE
1.DTC REPRODUCTION PROCEDURE
Turn the ignition switch ON.
Perform ABS actuator and electric unit (control unit) self-diagnosis.
Is DTC “C1110” detected?
YES
>>
Proceed to diagnosis procedure. Refer to
Diagnosis Procedure
.
NO
>>
INSPECTION END
Diagnosis Procedure
1.REPLACE ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
■ CAUTION ■
Replace ABS actuator and electric unit (control unit) when self-diagnostic result shows items other than those applicable.
>>
Replace ABS actuator and electric unit (control unit).
Special Repair Requirement
1.STEERING ANGLE SENSOR ADJUSTMENT, DECEL G SENSOR CALIBRATION, PRESSURE SENSOR CALIBRATION, AND VALVE CALIBRATION
After replacing an ABS actuator and electric unit (control unit), be sure to perform the following procedure.
Steering angle sensor adjustment: Refer to
Description (GT-R certified NISSAN dealer)
.
Decel G sensor calibration: Refer to
Description (GT-R certified NISSAN dealer)
.
Pressure sensor calibration: Refer to
Description (GT-R certified NISSAN dealer)
.
Valve calibration: Refer to
Description (GT-R certified NISSAN dealer)
.
>>
END
DTC DETECTION LOGIC
1.DTC REPRODUCTION PROCEDURE