C1164, C1165 CV SYSTEM

VDC/TCS/ABS

C1164 C1165

Description

The cut valve shuts off the normal brake fluid path from the master cylinder, when VDC/TCS is activated.

DTC DETECTION LOGIC

DTC	Display item	Malfunction detected condition	Possible cause
C1164	CV 1	When the control unit detects a malfunction in the CV1 system.	Harness or connector ABS actuator and electric unit (control unit)
C1165	CV 2	When the control unit detects a malfunction in the CV2 system.

DTC CONFIRMATION PROCEDURE

1.DTC REPRODUCTION PROCEDURE

1.CHECK CONNECTOR

2.CHECK SOLENOID, VDC SWITCH-OVER VALVE AND ACTUATOR RELAY POWER SUPPLY CIRCUIT

3.CHECK SOLENOID, VDC SWITCH-OVER VALVE AND ACTUATOR RELAY GROUND CIRCUIT

1.CHECK ACTIVE TEST

1.STEERING ANGLE SENSOR ADJUSTMENT, DECEL G SENSOR CALIBRATION, PRESSURE SENSOR CALIBRATION, AND VALVE CALIBRATION

ABS actuator and electric unit (control unit)		—	Voltage
Connector	Terminal
E41	32	Ground	Battery voltage

ABS actuator and electric unit (control unit)		—	Continuity
Connector	Terminal
E41	16	Ground	Existed
	47