CALIBRATION OF VALVE
INSPECTION AND ADJUSTMENT · VDC/TCS/ABS
Description
When doing work that applies to the list below, make sure to calibration of valve before running vehicle.
| Situation | Calibration of valve |
| Removing/Installing ABS actuator and electric unit (control unit) | — |
| Replacing ABS actuator and electric unit (control unit) | × |
| Removing/Installing brake components | — |
| Replacing brake components | — |
| Performing air bleeding from brake piping | — |
| Replacing brake fluid | — |
Special Repair Requirement
CALIBRATION OF VALVE■ CAUTION ■
- To calibrate valve, always use CONSULT-III.
(Calibration cannot be done without CONSULT-III) - Always perform the valve calibration after finishing the pressure sensor calibration. (If the pressure sensor calibration is not completed, the valve calibration cannot be performed.)
- Perform the valve calibration with the vehicle stopped.
- Never depress the brake pedal during the valve calibration.
1.PERFORM THE PRESSURE SENSOR CALIBRATION