CALIBRATION OF DECEL G SENSOR

INSPECTION AND ADJUSTMENT · VDC/TCS/ABS

Description
Special Repair Requirement

Description

When doing work that applies to the list below, make sure to calibrate decel G sensor before running vehicle.

×: Required –: Not required

Situation	Calibration of decel G sensor
Removing/Installing ABS actuator and electric unit (control unit)	×
Replacing ABS actuator and electric unit (control unit)	×
Removing/Installing steering components	—
Replacing steering components	—
Removing/Installing suspension components	—
Replacing suspension components	—
Changing old tires to new ones	—
Adjusting wheel alignment	—
Removing/Installing yaw rate/side/decel G sensor	×
Replacing yaw rate/side/decel G sensor	×

Special Repair Requirement

CALIBRATION OF DECEL G SENSOR

■ CAUTION ■

To calibrate decel G sensor, always use CONSULT-III.
(Calibration cannot be done without CONSULT-III)

Perform the G sensor calibration only with the vehicle parked on level surface.

1.ALIGN THE VEHICLE STATUS

2.PERFORM THE CALIBRATION OF DECEL G SENSOR

3.CHECK DATA MONITOR

4.ERASE THE SELF-DIAGNOSIS MEMORY