CALIBRATION OF PRESSURE SENSOR

1. On the CONSULT-III screen, touch “WORK SUPPORT” and “PRESS SEN CALIBRATION” in order.
2. Touch “START”.
3. After approximately 10 seconds, touch “END”.
4. Turn the ignition switch OFF, then turn it ON again.
   ■ CAUTION ■
   Always perform the above operation.
   

>> GO TO 2.

Select “PRESS SENSOR” in “DATA MONITOR” and check pressure sensor signal.

Condition	DATA MONITOR
Brake pedal is released	Approx. 0 bar
Brake pedal is depressed	Approx. 0 – 300 bar

YES>>GO TO 3.

NO>>Check pressure sensor. Refer to Diagnosis Procedure (GT-R certified NISSAN dealer).

Erase the self-diagnosis memories of the ABS actuator and electric unit (control unit). Refer to CONSULT-III Function (GT-R certified NISSAN dealer).

YES>>INSPECTION END

NO>>Check the items indicated by the self-diagnosis.