Hill start assist
VDC/TCS/ABS
System Diagram
System Description
- The hill start assist assists the driver during uphill parking by maintaining the brake fluid level and preventing the vehicle from rolling backward until the driver depresses the accelerator.
- This is intended for assistance on starting the vehicle. Releasing the brake pedal, pressure is gradually reduced after maintaining the brake pressure for 2 seconds. In addition, automatic brake releasing enables a smooth start whenever ready.
Component Parts Location
|
1. |
Steering angle sensor |
2. |
ABS warning lamp |
3. |
Brake warning lamp |
|
4. |
VDC OFF indicator lamp |
5. |
SLIP indicator lamp |
6. |
Front wheel sensor |
|
7. |
Set-up switch (VDC) |
8. |
ABS actuator and electric unit (control unit) |
9. |
Yaw rate/side/decel G sensor |
|
10. |
Rear wheel sensor |
|
|
|
|
|
A. |
Back of spiral cable assembly |
B. |
Combination meter |
C. |
Steering knuckle |
|
D. |
Instrument center panel |
E. |
Inside brake master cylinder cover |
F. |
Under rear console assembly |
|
G. |
Rear final drive assembly |
|
|
|
|