PRECAUTIONS

■ CAUTION ■

• Never apply 7.0 V or more to the measurement terminal.
  
• Use a tester with open terminal voltage of 7.0 V or less.
  
• Turn the ignition switch OFF and disconnect the battery cable from the negative terminal when checking the harness.
  

• Solder the repaired area and wrap tape around the soldered area.
  
  
  NOTE：
  A fray of twisted lines must be within 110 mm (4.33 in).
  
  
• Bypass connection is never allowed at the repaired area.
  
  
  NOTE：
  Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.
  
  
• Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.