MAIN LINE BETWEEN STRG AND DLC CIRCUIT

1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect the following harness connectors.
• ECM
• Steering angle sensor
4. Check the continuity between the steering angle sensor harness connector and the data link connector.
   

   Steering angle sensor harness connector		Data link connector		Continuity
   Connector No.	Terminal No.	Connector No.	Terminal No.
   M37	5	M24	6	Existed
   	2		14	Existed

   
   

YES (Present error)>>Connect all the connectors and diagnose again. Refer to Trouble Diagnosis Flow Chart.

YES (Past error)>>Error was detected in the main line between the steering angle sensor and the data link connector.

NO>>Repair the main line between the steering angle sensor and the data link connector.