THE SEAT BELT WARNING CONTINUES SOUNDING, OR DOES NOT SOUND

1. Turn ignition switch ON.
2. Check the operation of the seat belt warning lamp in the combination meter.
   

   Seat belt fastened	: OFF
   Seat belt not fastened	: ON

   
   

YES>>GO TO 2.

NO>>GO TO 4.

Check if the light reminder warning chime is activated by performing BCM active test. Refer to CONSULT-III Function (BCM - BUZZER).

YES>>INSPECTION END

NO>>GO TO 3.

Check if buzzer switches to proper condition (On/Off) on data monitor of combination meter. Refer to CONSULT-III Function (METER/M&A).

Buzzer active condition	: On
Buzzer non-active condition	: Off

YES>>Replace the combination meter.

NO>>Replace the BCM. Refer to Removal and Installation.

Perform the check for the seat belt buckle switch circuit. Refer to Diagnosis Procedure.

YES>>GO TO 5.

NO>>Repair harness or connector.

Perform a unit check for the seat belt buckle switch. Refer to Component Inspection (Belt Buckle Switch).

YES>>Replace the combination meter.

NO>>Replace the seat belt buckle. Refer to Removal and Installation.