TRUNK
DIAGNOSIS SYSTEM (BCM)
BCM CONSULT-III FUNCTIONCONSULT-III performs the following functions via CAN communication with BCM.
| Diagnosis mode | Function Description |
| DATA MONITOR | The BCM input/output signals are displayed. |
| ACTIVE TEST | The signals used to activate each device are forcibly supplied from BCM. |
DATA MONITOR|
Monitor Item |
Contents |
|
|
PUSH SW |
Indicates [ON/OFF] condition of push-button ignition switch. |
|
|
UNLK SEN -DR |
NOTE：
This item is displayed, but cannot be monitored.
|
|
|
VEH SPEED 1 |
Indicates [km/h] condition of vehicle speed signal from combination meter. |
|
|
KEY CYL SW-TR |
NOTE：
This item is displayed, but cannot be monitored.
|
|
|
TR CANCEL SW |
NOTE：
This item is displayed, but cannot be monitored.
|
|
|
TR/BD OPEN SW |
Indicates [ON/OFF] condition of trunk lid opener switch. |
|
|
TRNK/HAT MNTR |
NOTE：
This item is displayed, but cannot be monitored.
|
|
|
RKE-TR/BD |
NOTE：
This item is displayed, but cannot be monitored.
|
|
ACTIVE TEST|
Test item |
Description |
|
TRUNK/GLASS HATCH |
This test is able to check trunk lid opener actuator open operation. |