TRUNK LID OPENER ACTUATOR

1. Perform Active Test (“TRUNK/GLASS HATCH”) with CONSULT-III.
2. Touch “OPEN” and check that trunk lid opens.

YES>>Trunk lid opener actuator is OK.

NO>>Refer to Diagnosis Procedure.

1. Turn ignition switch OFF.
2. Disconnect trunk lid lock assembly connector.
3. Check voltage between trunk lid lock assembly harness connector and ground.

(+)		(–)	Condition	Voltage (V) (Approx.)
Trunk lid lock assembly (trunk lid opener actuator)
Connector	Terminal
B352	3	Ground	Trunk lid opener switch is ON	0 → Battery voltage → 0

YES>>GO TO 3.

NO>>GO TO 2.

1. Disconnect BCM connector.
2. Check continuity between BCM harness connector and trunk lid lock assembly (trunk lid opener actuator) harness connector.
   

   BCM		Trunk lid lock assembly (trunk lid opener actuator)		Continuity
   Connector	Terminal	Connector	Terminal
   M120	23	B352	3	Existed

   
   
3. Check continuity between BCM harness connector and ground.
   

   BCM		Ground	Continuity
   Connector	Terminal
   M120	23		Not existed

   
   

YES>>Replace BCM. Refer to Removal and Installation.

NO>>Repair or replace harness.

Check continuity between trunk lid lock assembly (trunk lid opener actuator) harness connector and ground.

Trunk lid lock assembly		Ground	Continuity
Connector	Terminal
B352	2		Existed

YES>>Replace trunk lid lock assembly. Refer to Removal and Installation

NO>>Repair or replace harness.