HOOD SWITCH

1. Select “HOOD SW” in “Data Monitor” mode with CONSULT-III.
2. Check the hood switch signal under the following condition.

Test item	Condition		Status
HOOD SW	Hood	Open	ON
		Close	OFF

YES>>Hood switch is OK.

NO>>Go to Diagnosis Procedure.

1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connector E9 and hood switch connector.
3. Check continuity between IPDM E/R harness connector and hood switch harness connector.
   

   IPDM E/R		Hood switch		Continuity
   Connector	Terminal	Connector	Terminal
   E9	104	E85	2	Existed

   
   
4. Check continuity between IPDM E/R harness connector and ground.
   

   IPDM E/R		Ground	Continuity
   Connector	Terminal
   E9	104		Not existed

   
   

YES>>GO TO 2.

NO>>Repair or replace harness.

1. Connect IPDM E/R connector.
2. Check voltage between IPDM E/R harness connector and ground.

(+)		(–)	Voltage (V) (Approx.)
IPDM E/R
Connector	Terminal
E9	104	Ground	Battery voltage

YES>>GO TO 3.

NO>>Replace IPDM E/R. Refer to Removal and Installation.

Refer to Component Inspection.

YES>>GO TO 4.

NO>>Replace hood switch.

Refer to Intermittent Incident.

>>INSPECTION END

1. Turn ignition switch OFF.
2. Disconnect hood switch connector.
3. Check continuity between hood switch terminals.
   

   Hood switch		Condition		Continuity
   Terminal
   1	2	Hood switch	Press	Not existed
   			Release	Existed

   
   

YES>>INSPECTION END

NO>>Replace hood switch. (Built is hood lock RH.)