Nissan GT-R (R35) · Service Manual TRANSMISSION & DRIVELINE

P0765 SHIFT SOLENOID VALVE 4

TRANSMISSION: GR6Z30A

P0765

Description


  • The shift solenoid valve 4 is installed on the actuator control module and switches the oil passages for the oil pressure that activates the 1st-Reverse shift actuator operating the sleeve B1 and the 3rd-5th shift actuator operating the sleeve B2.
  • The shift solenoid valve 4 is a ON/OFF type solenoid valve.

DTC Logic

 
 DTC DETECTION LOGIC

DTC
 		Self-diagnosis name
 		DTC detection condition
 		Possible cause
P0765
 		Shift solenoid valve 4 output
  • A DTC is set if the shift solenoid valve 4 monitor value is ON when the shift solenoid valve 4 command value is OFF.
  • A DTC is set if the shift solenoid valve 4 monitor value is OFF when the shift solenoid valve 4 command value is ON.
  • Shift solenoid valve 4
  • Harness or connector
    (Open or short in the shift solenoid valve 4 circuit)

 
 DTC CONFIRMATION PROCEDURE

 
 1.PREPARATION BEFORE OPERATION
 
 2.PERFORM DTC CONFIRMATION PROCEDURE (PART 1)
 
 3.PERFORM DTC CONFIRMATION PROCEDURE (PART 2)

Diagnosis Procedure


 
 1.CHECK GROUND CONNECTION
 
 2.CHECK SHIFT SOLENOID VALVE 4 CIRCUIT
 
 3.CHECK SHIFT SOLENOID VALVE 4
 
 4.CHECK HARNESS BETWEEN TCM AND TRANSMISSION (SHIFT SOLENOID VALVE 4) (PART 1)
 
 5.CHECK HARNESS BETWEEN TCM AND TRANSMISSION (SHIFT SOLENOID VALVE 4) (PART 2)
 
 6.CHECK INTERMITTENT INCIDENT

Component Inspection


 
 1.CHECK SHIFT SOLENOID VALVE 4