Nissan GT-R (R35) · Service Manual TRANSMISSION & DRIVELINE

P2713 AXIS B FEED PRESSURE SOLENOID VALVE

TRANSMISSION: GR6Z30A

P2713

Description


  • The axis B feed pressure solenoid valve is installed on the actuator control module and builds up the source pressure for the gear operation actuators for odd number gears and reverse gear and for the clutch B pressure solenoid valve based on the signals from TCM. The solenoid valves adjust the source pressure to drive the gears and clutches.
  • The axis B feed pressure solenoid valve is a N/L type (normal low) in which no control oil pressure is built up when no current flows through the coil.

DTC Logic

 
 DTC DETECTION LOGIC

NOTE：
 If DTC P0700 is displayed, perform the diagnosis of DTC P0700 first. Refer to DTC Logic (GT-R certified NISSAN dealer).

DTC
 		Self-diagnosis name
 		DTC detection condition
 		Possible cause
P2713
 		Axis B feed pressure solenoid valve current
 		A DTC is set if the axis B feed pressure solenoid valve monitor current value is less than 0.2 A when the axis B feed pressure solenoid valve target current value is more than 0.38 A.
  • Axis B feed pressure solenoid valve
  • Harness or connector
    (Open or short in the axis B feed pressure solenoid valve circuit)

 
 DTC CONFIRMATION PROCEDURE

 
 1.PREPARATION BEFORE OPERATION
 
 2.PERFORM DTC CONFIRMATION PROCEDURE

Diagnosis Procedure


 
 1.CHECK GROUND CONNECTION
 
 2.CHECK AXIS B FEED PRESSURE SOLENOID VALVE CIRCUIT (PART 1)
 
 3.CHECK AXIS B FEED PRESSURE SOLENOID VALVE CIRCUIT (PART 2)
 
 4.CHECK AXIS B FEED PRESSURE SOLENOID VALVE
 
 5.CHECK HARNESS BETWEEN TCM AND TRANSMISSION (AXIS B FEED PRESSURE SOLENOID VALVE) (PART 1)
 
 6.CHECK HARNESS BETWEEN TCM AND TRANSMISSION (AXIS B FEED PRESSURE SOLENOID VALVE) (PART 2)
 
 7.CHECK INTERMITTENT INCIDENT

Component Inspection (Axis B Feed Pressure Solenoid Valve)


 
 1.CHECK AXIS B FEED PRESSURE SOLENOID VALVE (PART 1)
 
 2.CHECK AXIS B FEED PRESSURE SOLENOID VALVE (PART 2)