TRUNK LID OPENER CANCEL SWITCH

With CONSULT-III
Check trunk lid opener cancel switch (“TR CANCEL SW”) in Data Monitor mode with CONSULT-III.

Monitor item	Condition
TR CANCEL SW	Trunk lid opener cancel switch is turned to “ON”: ON
	Trunk lid opener cancel switch is turned to “OFF”: OFF

YES>>Trunk lid opener cancel switch is OK.

NO>>Refer to Diagnosis Procedure.

1. Turn ignition switch OFF.
2. Disconnect trunk lid opener cancel switch connector.
3. Check voltage between trunk lid opener cancel switch harness connector and ground.
   

   (+)		(–)	Voltage (V) (Approx.)
   Trunk lid opener cancel switch
   Connector	Terminal
   M105	1	Ground

   
   

YES>>GO TO 3.

NO>>GO TO 2.

1. Disconnect BCM connector.
2. Check continuity between BCM harness connector and trunk lid opener cancel switch harness connector.
   

   BCM		Trunk lid opener cancel switch		Continuity
   Connector	Terminal	Connector	Terminal
   M123	129	M105	1	Existed

   
   
3. Check continuity between BCM harness connector and ground.
   

   BCM		Ground	Continuity
   Connector	Terminal
   M123	129		Not existed

   
   

YES>>Replace BCM. Refer to Removal and Installation.

NO>>Repair or replace harness or connector.

Check continuity between trunk lid opener switch harness connector and ground.

Trunk lid opener cancel switch	Terminal	Ground	Continuity
M105	2		Existed

YES>>GO TO 4.

NO>>Repair or replace harness.

Refer to Component Inspection.

YES>>GO TO 5.

NO>>Replace trunk lid opener cancel switch. Refer to Removal and Installation.

Refer to Intermittent Incident.

>>INSPECTION END

1. Turn ignition switch OFF.
2. Disconnect trunk lid opener cancel switch connector.
3. Check continuity between trunk lid opener cancel switch terminals.
   

   Terminal		Condition	Continuity
   Trunk lid opener cancel switch
   1	2	ON	Existed
   		OFF (cancel)	Not existed

   
   

YES>>INSPECTION END

NO>>Replace trunk lid opener cancel switch. Refer to Removal and Installation.